![]() If the gears are worn down, this would cause this symptom. ![]() ![]() Insert the screwdriver inside the drill chuck to tighten the chuck screw, remembering that the screw is reversed thread. Use the key to tighten the drill chuck on the drill, then loosen the drill chuck and remove the allen key. Install the new drill chuck by threading it on the spindle and then insert the allen key and tighten the chuck on the key. ![]() Once loosened, continue to remove from the spindle. A second method is to hit the allen key quickly with a hammer to loosen. Now, insert a pipe over the allen key for leverage and turn counter clockwise to loosen the chuck. With the screw removed, insert a big allen key in the chuck and tighten firmly. Once you have broken the tightness of the screw, loosen the chuck and continue to remove the screw. Snug the chuck against the screwdriver and loosen by turning it clockwise (this is reversed thread). If you determine that the drill chuck needs to be replaced to solve this problem, begin by inserting the proper screwdriver into the chuck to remove the screw at the bottom. Remember, this screw is reversed thread so turn it counter clockwise to tighten. To solve this problem, insert the proper screwdriver in the drill chuck and tighten. If it is loose, it can prevent movement of the teeth. If the chuck is stuck open, check that the screw inside the drill chuck is fasten tight. However, if the problem continues, replace the drill chuck. If they are not even at the tip, you can gently tap them in place with a hammer to realign. With the drill bit removed, close the chuck and inspect the jaws for alignment. If it is seized closed, you can release the jaws with channel lock pliers. ![]() If the drill chuck is seized open, or closed, it will need to be repaired. The drill chuck holds the drill bit in place with jaws that firmly clamp down on it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |